This shows how Knotter can be used to trace a knot from a picture of the knot.
Thank you for some other informative website. Where else may I get that type of info written in such an ideal way? I've a mission that I'm just now operating on, and I've been on the look out for such information. debcckdfkkeddbda
Fine-tuning the graph
Here is the result of the previous part, with the background disabled.
We need to make the design more symmetrical, for this we will be using the grid.
We start with a 16px square grid and move the center to one of the central nodes.
Click Move... on the grid dialog and then click on the desired node to move the grid.
No we switch from the Edge chain tool to the Edit graph tool.
With that node selected we change the minimum angle required to trigger a cusp in the selection style dialog. This will affect only the selected node. Since the angle is 180°, something less than that will suffice. A value too low (below 90° in this case) will trigger extra cusps also for the lines leading down.
We can now change the style and display to make it more appealing.
Now the knot is complete!